| Characteristics and description |
|---|
Company name Private person |
The purpose of the floor and the room itself Floor for the shop in Stupino |
Type of floor topping floors |
Thickness of the concrete layer 150 cm |
Room area 213 m² |
Work on this object was carried out in the summer. It was quite warm outside, which contributed to the rapid delivery of the object. The client planned to make a welding shop out of the premises. In this regard, the customer needed a flat concrete floor.
Terms of work Number of days for all work: 5 |
Requirements for the quality of work Floors must comply with SNiP 2.03. 13-88 |
Appearance of floors Must look presentable |
Durability Service life of floors without repair (years): 10 |
Total cost Budget within the framework of: 500 000 ₽ |
According to the project, the client planned a concrete floor reinforced with reinforcing mesh, but we offered a more economical solution without compromising quality. We suggested using polypropylene fiber instead of reinforcing mesh. This technology is ideal for this room, if we take into account the loads that the customer planned. Reinforcing mesh, in turn, would be a strong blow to the budget.
The technology we have proposed has reduced the cost by 30%, because fiber is cheaper than rebar. It significantly reduces the production time, because it does not need to be reinforced with a reinforcing mesh. At the same time, concrete is already supplied with fiber.
Since the work was carried out in the warm season, we managed to fill 213 m2 in just a couple of hours. The old foundation consisted of construction debris. We applied the technology of liquid beacons for screed concrete mix, it is more complicated, but it is not inferior in evenness to the technology with guiding beacons. According to the general characteristics, it was a typical object, quite light.
When installing the floor on this object, there were no features, the concrete floor turned out to be of good quality with an error of 1 mm per 1 m2 – this is almost perfect evenness. The client received a flat surface that can be used for production work.
The stages of the floor arrangement and the final result are shown in the photo below.
We are well aware that reviews of companies can be very different. Working in the construction market for more than 15 years, we have faced various situations.
We have both satisfied customers and those who are not. But, there is one important thing: we always bring the cycles of our provision to the end. If a client has problems, then we do not leave him with them, but settle them to a full and final conclusion.
Working with us, you can be sure that we will make you an industrial floor that is exactly right for the task for which you needed it.
Thanks to a good knowledge of the technology of industrial floors, we have gathered a lot of practical experience in using floor structures in various difficult places. We solve non-trivial problems and often, when we take an order, 3-4 companies have already tried to take it before us, but refused due to the complexity of the object.